Operation Manual
This section explains how
to
operate the 9200
in
Edit mode.
In
this
mode, you
can
call
up the various effect panmeters which make up the programs of the
9200,
and you
can
freely edit the parameters to your desired values.
Pmgram
Configuration
Architecture
II
Uses two sets of stereo inputs and outputs. Up to two
Before you attempt to edit any parameters, you should
effects can be used in this program architecture (effect
have
an
understanding of the program architectures
and
type
B
in effect modulcs
1
and 2).
effect modules offered
by
the 9200. This will make it
easier for you to achieve the desired results.
The
9200
has four different program architectures.
A
program architecture is characterized by the number of
effects it contains and
by
the input/output signal routing.
The available program architectures arc
as
follows.
Architecture
I
Uses one set of stereo inputs
and
outputs.
Only
one
effect can be used in this program architecture (effect
type
C
in
effect module
1).
Architecture
111
Uses two monaural inputs and outputs and one
set
of
stereo inputs and outputs. Up to three effects can
be
used in this program architecture (effect
type
B
in effect
module
1,
effect type
A
in effect modules 2 and 3).
Architecture
IV
Uscs four monaural inputs and outputs. Up to four
effects can be used in this program architecture (effect
type
A
in effect modules
l,
2,3,
and
4).
Architecture
I
IN
OUT
Architecture II Architecture
II
I
OUT
IN
OUT
1
I
Architecture
iV
IN
OUT
------------------.
Program Architecture Configuration