Operation Manual

2. Use the SELECT key to move the cursor (,F) and
listen either to "Original" (program before editing)
or "Buffer" (edited program in buffer).
Last Edit
To call up this page from the Program mode, you press
the following keys:
7 EDIT
0 V A SELECT ODlAL
IZ
3. To terminate the Compare function, press the
UTILITY key again.
OUTILTPI 0 MUTE EXIT MKXlTE
m
The unit reverts to the Edit mode.
EDIT VIA key
.L
UTILITY key
L
a FUNCTION 2 key
The 9200 lets you freely edit any chosen program, for
example to fit the mood of a performance. However,
when putting the final touches on program, calling
up the
same two or three parameters repeatedly using the
regular procedure is quite tedious.
The Last Edit page is very convenient in such an
instance,because it always remembers the last three
edited parameters before the current one. Simply
by
using the FUNCTION key 1 - 4 on this page, you can
select the desired parameter for renewed editing. It does
not matter if the parameters were from various different
pages or
if you have changed modules in the meantime.
The Last Page makes even complicated editing
operations a snap.
The Last Edit page information is stored in the user area
as part of the program data.
A NOTE
If the eflect type used by the currently edited module was
changed,
all parameters ofthut module are replaced.
Therefore the previously edited parameters in
that module are
not remembered and cannot be recalled with the Last Edit
page.