Operation Manual
Duplicate
To call up this page from the Program mode, you press
To
call up this page from the Program mode, you press
the following keys:
the following keys:
EDIT
V/A
key
4
UTILITY key
4
FUNCTION
3
key
This page lets you select "Copy" function to copy a
parameter setting to another or "Swap" function to swap
parameter settings.
Copy helps you to make it easier to use a parameter
setting out of the preset programs or so for your new
program. With Swap, you can exchange the two effects
for input and output with each other without re-
connection, for instance.
EDIT
V/A
key
L
UTILITY key
4
FUNCTION
3
key
L
FUNCTION
1
key
This function lets you copy
an
effect of the same effect
type
(A,
B,
or C)
as
used by the currently edited effect
module into any desired memory area (including the
active buffer).
Since the effect is copied with all its parameter settings,
you can fully replicate an effect in the active buffer or
used by another program (provided the effect is of the
same
efkct type).
A
NOTE
Only the parameters of the eflect are copied, not any effect
link settings or the program name.
The available copy source depends on the currently edited
effect module.
A rchitecture I, module
l
The effect type
C
can be used. An effect can be copied from
any program of architecture I.
Architecture II, module
l
The efjfect type
B
can be used. An effect can be copied from
module
2 in the active buger, from module
1
or
2
of
any
program of architecture 11, or from module
I
of any
program
of
architecture III.