Operation Manual

3. Turn the Dial to select the copy source area, program
4. Press the EXECUTE key.
number and module number,
The following verification message appears.
UTILITY 0 MUTE WIT ECUJlE
When the EXECUTE key is pressed once more, the
selected effect and its parameter settings are copied to the
currently edited module.
A NOTE
When module 3 of architecture IV was selected as a copy
source, turning the
Dial by one click to the right will select
module
4 in the active buger as copy source. Turning the Dial
further right will switch
to other memory areas and modules
available
as copy source.
Turning the
Dial by one click to the left will select the current
module in the active bumr
as copy source, and turning the
Dial further left wiU switch to module 1 in the active buffer,
and then to other memory areas and modules available as
copy source.
5. If you change your mind, press the EXIT key while
the "Sure?" message is displayed. The Copy
operation is canceled
and the unit reverts to the
previous display.
When wishing to change the copy target effect module, you
can temporarily leave the
Edit Utility mode and select another
module.