Operation Manual

Formatting a RAM Card
Store
Before a new RAM card can be used, it must be
formatted by the
9200. If an unformatted card is inserted
in the card slot and
a card page menu is selected, the
message "CARD Error" appears on the display.
To format a RAM
card, proceed as follows.
Insert
the unformatted card into the card slot and select
the "Card Save" option from the Card page. Following
the "CARD Error" indication, the message "FORMAT
OK?" flashes on the display.
If you press the EXECUTE key in this condition, the card
will be formatted. After the process is finished, the
message "FORMAT Completed" appears and the unit
reverts
to the "Card Save" page.
Use only the dedicated RAM-32 cards. Other RAM cards
cannot be used. The formatting is not compatible with the
formatting of
RAM cards in the ZOOM 9010. If you want to
use a
RAM card of the 9010 with the 9200, you must format it
once more on the 9200.
This page serves to store the currently selected program
in the user
area or on a RAM card.
After you press the
FUNCTION 4 key at the Utility
mode main menu, the currently selected program number
flashes, which indicates that this number is being offered
as the store target.
When the EXECUTE key is pressed, the following
verification message appears.
When the EXECUTE key is pressed once more, the
selected program is stored at the same program number.
The following indication briefly appears on the display,
and then the unit reverts to the initial Store page.
If you press the EXIT key while the "Sure?" message is
displayed, the Store operation is canceled and the unit
reverts to the previous display.
The functions and operation steps of this page are identical to
the Store page in the Edit Utility mode, except for the position
of the
lit indicators and the fact that the unit reverts to the
Program mode when the UTILITY key or EXIT
key is
pressed. For details on the store operation, please refer to
page
37.