Operation Manual

Terns Used in This Manual
Electrical Interference
The 9200 uses digital circuitry that may cause
interference and noise if placed too close to other
electrical equipment, such as TV sets and radio receivers.
If such problems occur, move the 9200 further away from
the affected equipment. Also, when fluorescent lights or
devices with built-in motors are in close proximity to the
unit,
the 9200 may not function properly.
Cleaning
Use a soft, dry cloth to clean the 9200. If necessary, you
may slightly moisten the cloth. Do not use any abrasive
cleansers, waxes, or solvents (such as paint thinner or
cleaning alcohol), since these may dull the finish or
damage the surface.
In Case of Malfunction
If a problem arises during operation, turn the 9200 off
and disconnect all cables. Then contact your local
ZOOM
distributor with the following information: model name,
serial number, symptom, your name, address and phone
number.
Keep this manual in
a convenient place for future
reference.
Up to four effects can be used by the 9200. Such a
combination of effects, together with their parameter
settings, can be given a name and stored as a program.
The 9200 has a total of
32 effects which are divided into
the three effect types
A, B, and C. The effect types differ
according
to the processing principles that are employed.
For a list of effects, please refer to page 20.
Effect Module
To be used by the 9200, an effect is placed into an effect
module. Each effect module contains one
effect.
Program
INPUT Effect Module OUTPUT
Effect Module
,IIE