User Manual

123
4. Disconnect the cable connector
that connects the battery and the
battery holder.
5. Remove the battery from the
battery holder.
■
Installing a battery
1. Put the battery into the battery
holder.
2. Connect the battery and battery
holder with the cable.
− (Black)
+ (Red)
3. Install the battery holder in the
Ring Controller.
4. Tighten the screw and replace the
cap.
Changing the Ring Controller
battery
Change the battery if it begins to run out of
power quickly or cannot be charged.
NOTE
Always use a ZOOM BT-04 rechargeable
battery.
■
Checking the remaining battery
charge
1. Press p on the Ring
Controller.
The remaining battery charge of the Ring
Controller will be shown on the display.
■
Removing the battery
1. Remove the cap from the back of
the Ring.
The cap is below z.
Ring Controller bottom
2. Remove the screw under the cap.
Use a Phillips head screwdriver to
remove the screw.
3. Pull the battery holder out.
Ring Controller settings (continued)