User Manual

67
Reverse: Use 1 on Setting screen 3
to reverse the playback direction of the
captured audio.
NOTE
The LOOPER mode tempo sync function
(
→
P. 95) cannot be used if BPM and Length
are not set. You can also set these later.
4. Use e to select "Assign to
LOOPER", and press E.
The screen where you can assign cap-
tured audio to pads opens.
Press M or C to return to the previ-
ous screen.
5. To change the name of the cap-
tured audio, use e to select
RENAME, and press E.
You can edit the name of the captured
recording.
6. Use u to select the pad bank
(
→
P. 71) to which to assign the
captured audio.
The pad bank name changes at the
bottom of the screen.
■
Editing captured audio to use in
LOOPER mode
Make the following settings to use captured
audio in LOOPER mode.
1. Use e to select "Assign to
LOOPER".
2. Use 1 and 3 to set the range
of the captured audio to assign to
the pad.
1: Start point
Change the starting point of the captured
audio.
3: End point
Change the ending point of the captured
audio.
When setting start and end points, the
waveforms around those points are
shown magnied.
3. Use 2 to show the following
settings.
The following settings can be made.
BPM: Use 1 on Setting screen 2 to set
the tempo of the captured audio.
Length: Use 3 on Setting screen 2 to
set the length of the captured audio.
Capturing audio (continued)