User manual

11
address, and a Password. These are NOT the User ID and
Password that you used to get into the Basic Setup menu.)
Click Next three times to reach the Summary Page of the
setup.
If a 1483 Bridged IP+NAT or 1483 Routed IP connection is
detected, click Next until you reach the Summary Page of the
setup.
7 On the Summary Page, click Save/Reboot.
Congratulations! If you want to connect your X5 to only one
computer, you are now done. Your modem is connected. To test
your installation, open your browser and go to a familiar Web site.
If your browser works, installation is complete for the computer
you used for setup. If your browser doesn't work, please refer to
Appendix D: Troubleshooting Tips on page
54.
Read This Only if You Are Manually
Entering Information Into the Basic
Setup Page
If your service provider gave you Protocol, VPI, VCI, and
Encapsulation settings and you are choosing to manually enter
information into the Basic Setup page, do the following:
a Leave the PVC box at PVC0.
b If you have this information (Protocol,
Encapsulation, VPI, and VCI), select the correct
Protocol from the list. If you were not given this
information, please refer to the ADSL Internet
Settings Tables at the end of this Quick Start to
find Protocol, Encapsulation, VPI, and VCI
information for your provider / country.
c Enter the Encapsulation, VPI, and VCI in the
appropriate boxes.
d If you selected PPPoE or PPPoA as your
Protocol, your provider should have given you a
User ID or User Name (usually your email
address or the characters preceding the @ sign in
your email address) and a Password. (These are