User manual

12
NOT the User ID and Password that you used to
get into the Basic Setup menu.)
If you cannot remember or cannot find your User
ID and Password, call your service provider and
ask for them. Then enter them in the appropriate
boxes. This information is required for PPPoE
and PPPoA protocols.
e If you selected 1483 Bridged IP+NAT or 1483
Routed IP as your Protocol, your provider
should have given you four series of numbers for
the IP (Internet Protocol) Address, Subnet
Mask, Gateway, and DNS. Enter these numbers
in the appropriate boxes, and select Use the
Following IP Address.
f Click Save/Reboot.
g Your modem should now be properly connected.
To test your installation, open your browser and
go to a familiar Web site. If your browser works,
installation is complete for the computer you used
for setup. In that case continue at If Your
Browser Works below. If your browser doesn't
work, please refer to the section If Your Browser
Doesn’t Work below.
Click X to close the window. Your basic setup is complete!
The options that are set in the Basic Setup page are sufficient for
most users. However, those who want or need to change the
modem’s settings can do so using the Advanced Setup page.
If your Browser Works
Please consider these things:
A) Are you using your ADSL modem on the same phone line
where you’re also using other equipment such as telephones or