User manual

16
you are connecting a network device such as a wireless access
point or switching hub, go to step 4 below.
4 Set up your network device by using the instructions that came
with that device. Then reboot any computer that is part of
your network. For example, if you connected a wireless access
point, reboot any computer that will make a wireless
connection to that wireless access point.
5 Verify that your Internet connection is working. Open the
Web browser (e.g., Internet Explorer or Mozilla Firefox) on
each computer or other device using your network and try to
connect to a familiar Web address.
Note: If at any time you need to make changes to the ADSL
modem configuration, open a web browser from any PC on
your ADSL modem’s network and type 192.168.1.1 to open
the modem’s Setup pages. Alternately, you can connect a
computer directly to the X5, open its browser, and then type
192.168.1.1. Note also that you can configure the Management
section of the X5 Setup pages to permit configuration from a
remote location.
Congratulations! You have connected an additional device to the
Internet. You can connect up to 4 devices to the X5, following the
instructions above for each device and starting at Step 2. When
you are finished, your setup may be complete. Please check the
Contents on page 3 to see whether there’s anything relevant to you
in chapters 3, 4, 5, 6, or the Appendix. If not, you should be all set
to enjoy your X5.