User manual

Click the Configure button and then the Renew DHCP

Lease button.

• If you are using a Windows computer, perform a

Release/Renew operation:

¾ Windows 2000/XP: From the desktop, click the Start

button, then point to Programs, point to Accessories,

and then select Command Prompt. Type ipconfig /all

and press the Enter key on your keyboard. In the

subsequent dialog box, make sure the NIC adapter is

listed, click Renew and then click Release. Then type

192.168.1.1 into your browser’s address bar, and the

Network Password box should display.

¾ For Windows 95/98/Me: From the desktop, click the

Start button and the point to Run. Type winipcfg, and

click OK. In the subsequent dialog box, make sure the

NIC adapter is highlighted in the drop-down list, click

Renew and then click Release. Then type 192.168.1.1 into

your browser’s address bar, and the Network Password

box should display.

Problem

The computer on which I initially installed the X5 on is connected

to the Web, but the computers

connected through my network

device cannot access the Internet.

Solution

The problem is most likely with your network device (such as a

wireless access point, router, hub, or switch). Check these items:

• Try rebooting each computer on your network. For example, if

you are using a router, reboot each computer that is connected

to the router. This will allow for the computers to release and

renew their IP addresses.

• If you are using a wireless access point or a router, verify that

the device is using Dynamic Host Configuration Protocol

(DHCP). This is also known as dynamic IP addressing.

Depending on your device, this may be controlled by an

Obtain an IP address automatically option. If you need