Operation Manual

29
You can also use 1 to change the step
unit.
HINT
If an instrument has been input at the current
step position, that pad will light brightly. Pads
that have not been input will be lit dimly.
3.
CONTROLLER
Tap the pad for the
instrument to be input.
The tapped pad will light brightly. Tap a
brightly lit pad to cancel its input. The
pad light will dim.
HINT
• Press u while pressing a pad to move
between steps and release the pad to sustain
the input sound to that step (note length).
• During step-by-step input, press P to
switch to real-time input.
4. Press S to end input.
This ends recording.
■
Playing the pattern
1. Press P.
Playback starts and P lights.
2. Press P again to pause.
Playback pauses and P blinks.
3. Press S to stop playback.
P becomes unlit when playback stops.
■
Clearing part of a pattern
1. Press P.
The pattern plays back.
2. Press C.
C will blink.
3.
CONTROLLER
While the part you
want to clear is playing back, press
the pad for the instrument to clear.
The sequence (performance data) will be
deleted while the pad is being pressed.
4.
CONTROLLER
Stop pressing the
pad when playback of the part you
want to clear has stopped.
5. Press C to stop clearing.
Real-time pattern input (continued)