Operation Manual

41
Selecting notes
In SCALE layout, you can select notes to input.
1. Turn e when SCALE layout is
active.
The note to be input appears in the
middle of the display.
Changing the last step position
on the Ring Controller
You can change the last step in the cycle on the
Ring Controller
By setting the cycle to 24 steps, you can create
patterns in triple time, for example.
1. Turn 3 to show the Last Step
value.
This shows the number of the last step
on the Ring Controller.
This can be set between 1 and 32.
NOTE
• If the Last Step is less than 32, sequence
data up to that step will not be cleared.
• If the Step setting is 1/32 or 1/16Tri, one step
will be 1/32nd of a bar. If the Step setting is
1/16 or 1/8Tri, one step will be 1/32nd of 2
bars. So, the timing change when setting the
Last Step will be dierent.
Inputting steps for patterns
that are longer than one Ring
Controller cycle
If the Step setting is 1/16 and the pattern
exceeds 2 bars or the Step setting is 1/32 and
the pattern exceeds 1 bar, the entire sequence
cannot be shown on the Ring Controller, so the
part of the sequence shown depends on the
playback position.
Screen during playback of bar 3
This icon appears when screen display
is changing with playback position
1. Press u to show the bar used for
step input.
The display will not change even when a
dierent bar is playing.
Bars shown
Pattern step input (continued)