Operation Manual

65
Adjusting and saving captured
audio
After capturing audio completes, the CAPTURE
settings screen opens, and the captured record-
ing begins loop playback.
The captured audio can be edited on the screen.
Start point
Start point
time
Reverse
playback setting
End point
time
End point
HINT
• Press P to pause and resume playback.
• Press S to stop playback and reset the
playback position to the beginning of the
loop.
• One Ring Controller cycle corresponds to
the time between start and end points. Press
P, and tap a pad to start playback of the
loop from that position. Tap a pad when
stopped to play only the interval assigned to
that pad.
• The playback position lights according to
the position of the captured audio during
playback.
■
Editing captured audio to use as
instruments assigned to pads
Make the following settings to use captured
audio in INST mode, for example.
1. Use e to select "Assign to INST
PAD".
2. Use 1 and 3 to set the range
of the captured audio to assign to
the pad.
1: Start point
Change the starting point of the captured
audio.
3: End point
Change the ending point of the captured
audio.
NOTE
The "INST remain" time shown on the display
is the remaining amount of time that can be
assigned to pads (maximum of 6 minutes
stereo or 12 minutes mono). Captured audio
that exceeds this length cannot be assigned to
the pads.
To make more time available, remove captured
audio from other pads or shorten intervals
between start and end points.
When setting start and end points, the
waveforms around those points are
shown magnied.
HINT
• Pressing any MODE button, M or C will
cancel editing of the captured recording and
reopen the original screen.
• Start and end points can be set after the rst
500 ms and before the last 500 ms of the
captured recording.
Capturing audio (continued)