Operation Manual

75
3. Press R.
This starts the precount. After the pre-
count, looper sequence recording will
start.
4.
CONTROLLER
Tap a pad that has
a captured recording assigned to
it.
The tapped pad will light according to the
capture animation type setting (
→
P. 77).
HINT
• If no animation has been set, the tapped pad
will light brightly.
• If even a single animation has been set, the
tapped pad will show the animation, and it
will light with the capture color.
• Up to 16 captured mono recordings can be
played back at the same time.
• What happens after captured recording
playback completes depends on the capture
playback mode setting (
→
P. 77).
5.
CONTROLLER
Tap other pads to
play their captured recordings.
HINT
The timing of when captured recordings start
playback depends on the quantize setting
(
→
P. 77).
6. Press S when all captured
recordings are done playing.
This ends looper sequence recording.
Recording the playback of
captured audio as looper
sequences in real-time
■
Switching pad banks
32 dierent captured recordings can be assigned
to each of the pad banks.
1. Press u.
This switches the pad bank and assigns
the 32 captured recordings in that bank
to the Ring Controller.
2. Tap a lit pad or use e to select a
captured recording.
The selected captured recording starts
playing and its name appears on the
display.
If a pad does not have a captured record-
ing assigned to it, assign one to it (
→
P. 61).
HINT
• By tapping the Ring Controller pads, you can
select and listen to them at the same time.
• Tap a pad while pressing Z to select it
without playing the captured audio.
• Press D when a pad is selected to open
the setting screen for the captured audio
(
→
P. 65).
Creating looper sequences