Operation Manual

91
4. Use 1, 2 and 3 to set
parameters.
Parameters can be set according to the
modulation type.
5. Press E when you are done
making settings.
This selects the outside of the block.
NOTE
When the following settings are made, addi-
tional settings will be shown.
· If the LFO Waveform is set to Pulse
The following screen will open, and you can
set the pulse width to 1–99%.
· If Envelope is selected
The following screen will open, and you can set
the envelope depth in a range between −100%
and +100%.
LED block settings
You can set the color used on the display and by
the Ring Controller LEDs, as well as how pads
light when a pad is tapped.
1. Press D.
2. Use e to select the LED block.
3. Use 1 to change the color.
You can select from 32 colors. When set
to OFF, LEDs will not light.
HINT
When you change oscillators, the LED color
will automatically change according to the
oscillator type.
4. Use 2 to select the animation to
use.
The animation can be set to O, Moire,
Firework, Cross, Circulation or Rainbow.
Off Moire
Lights spread in
a gradation
Lights spread
left and right
Side ring lights
CrossFirework
Light travels
clockwise
Rainbow lights
spread clockwise
RainbowCirculation
Editing sounds (continued)