Operation Manual

95
Setting the synchronization of
the captured audio (Sync)
The playback of the captured audio can be syn-
chronized with the looper sequence tempo.
1. Select a captured recording.
2. Press D.
The EDIT screen for the captured audio
of the selected pattern opens.
3. Use u to select Sync.
Settings related to synchronization are
shown.
4. Use 1 to turn synchronization on
or o (Tempo Sync).
When on, the captured audio will play
back synchronized with the looper
sequence tempo. In addition, loop play-
back will also be synchronized with the
tempo.
NOTE
To turn Tempo Sync On, the BPM and Length
parameters must also be set. If they are not
set, it cannot be turned on.
The following settings can be made with the
LOOPER mode EDIT screen.
LED settings
You can set the color used on the display and by
the Ring Controller LEDs, as well as how pads
light when a pad is tapped.
1. Select a captured recording.
2. Press D.
The EDIT screen for the captured audio
of the selected pattern opens.
3. Use e to select LED.
4. Use 1 to select a color.
5. Use 2 to select an animation
type.
The animation can be set to O, Moire,
Firework, Cross, Circulation or Rainbow
(
→
P. 92).
6. Use 3 to change the animation
playback timing.
This sets the repetition timing of the ani-
mation based on the playback tempo.
The interval can be set to 1/8, 1/4, 1/2, 1
or 2.
LOOPER mode EDIT screen