Operation Manual

96
Level and send settings
(Level/Send)
The playback level of captured audio and the
amounts sent to the delay and reverb effects
can be set.
1. Select a captured recording.
2. Press D.
The EDIT screen for the captured audio
of the selected pattern opens.
3. Use e to select Level/Send.
4. Use 1 to set the playback level
of the captured audio.
This can be set from 0 to 100.
5. Use 2 to set the amount sent to
the delay eect.
This can be set from 0 to 100.
6. Use 3 to set the amount sent to
the reverb eect.
This can be set from 0 to 100.
5. Use 2 to set the tempo of the
captured recording (BPM).
Set the original tempo of the captured
recording.
This can be set from 40.0 to 250.0.
6. Use e to select the length of the
captured recording (Length).
The length of the captured audio can be
set in units of quarter notes or bars.
NOTE
BPM and Length values must be set correctly
to synchronize accurately.
When Tempo Sync is O, the captured record-
ing is played back at its original speed. During
loop playback, the le will loop between its
start and end points without synchronizing to
the tempo.
LOOPER mode EDIT screen (continued)