User manual

7
II. This section will guide you on how to use the EZ Dual Cam as a digital still camera
• Unplug the camera from your PC system.
• Detach the USB cable from your camera.
• Turn on the EZ Dual Cam by pressing the Power Switch.
• Your camera will go through a 3 seconds self-test sequence (wait until all LED stop
blinking) and then the EZ Dual Cam is ready to use.
• Simply adjust the camera focus to the pre-calibrated hash mark for best picture focus.
• Use the Control Switch to adjust camera settings:
Function Arrow Key LCD Display Description
Clear
Memory
ç (Left) RESET
Pressing the left ç arrow, the LCD will display
"RESET". Then press shutter button while
displaying "RESET" to clear picture memory. Wait
for the "BEEP" to finish.
Self-Delay
Timer
è (Right) REC.
Pressing the Right è arrow, the LCD will display
"REC." Then press shutter button while displaying
"REC." to activate the 10 seconds auto-exposure
timer.
Picture
counter
ê (Down) N/A
Hold down the Down ê arrow to see remaining
picture count on the LCD panel.
Image Size
Select
é (Up) VGA
CIF
QCIF
Pressing Up é arrow to select preferred image
size.
Note: Number of picture count will increase in the following cases:
• Power OFF and ON the Dual Cam while using Battery Power or USB power.
• Changing image size.
The above actions will cause the available picture count to increase due to camera re-configuration of
available memory space.