User Manual
Table Of Contents
- Usage and safety precautions
- Introduction
- Terms used in this manual
- Part names
- Turning the power on
- Display information
- Adjusting effects
- Using the output booster
- Adjusting the master level
- Using patches
- Changing USB audio settings
- Changing various settings
- Using the tuner
- Using rhythms
- Using the looper
- Using the pedal
- Setting the tempo
- Setting how the TAP LED blinks
- Using as an audio interface
- Adjusting the pedal
- Restoring default settings and patches
- Updating the firmware
- Troubleshooting
- Rhythm List
- Specifications
42
• Recording stops and loop playback starts.
If the recording time is set to "MANUAL"
Loop playback will start when you press again or when the maximum recording time
is reached.
If the recording time is set to a musical note
Loop playback will start when the set recording time is reached.
HINT
• See P44 for how to set the LOOPER recording time.
• During phrase recording and playback, switching to MEMORY mode will not interrupt it.
NOTE
• During rhythm playback, recording will start after the precount.
• Changing a patch will stop phrase recording and playback. Moreover, this will delete the phrase recording
data.
• During rhythm playback, quantization is enabled so even if the recording ending time is not exact, the
loop will automatically be adjusted so that loop playback stays in time.
• Changing the tempo of a RHYTHM during loop playback will erase the recorded phrase.
Overdubbing a recorded phrase
• During loop playback, press
for the first unit in the LOOPER.
Stopping loop playback
With 1-unit looper
• During loop playback, press
twice for the unit using the looper.
• This stops the playback.
Using the looper