User Manual
Table Of Contents
- Usage and safety precautions
- Introduction
- Terms used in this manual
- Part names
- Turning the power on
- Display information
- Adjusting effects
- Using the output booster
- Adjusting the master level
- Using patches
- Changing USB audio settings
- Changing various settings
- Using the tuner
- Using rhythms
- Using the looper
- Using the pedal
- Setting the tempo
- Setting how the TAP LED blinks
- Using as an audio interface
- Adjusting the pedal
- Restoring default settings and patches
- Updating the firmware
- Troubleshooting
- Rhythm List
- Specifications
50
Using as an audio interface
The system requirements are as follows.
Compatible OS
Windows
Windows
®
7 (32-bit, 64-bit)
Windows
®
8.1 (32-bit, 64-bit)
Windows
®
10 (32-bit, 64-bit)
32-bit: Intel
®
Pentium
®
4 1.8 GHz or faster, RAM 1 GB or more
64-bit: Intel
®
Pentium
®
DualCore 2.7 GHz or faster, RAM 2 GB or more
Mac
OS X 10.9/10.10/10.11
macOS 10.12
Intel
®
CoreDuo 1.83 GHz or faster
RAM 1 GB or more
Quantization (bit-rate)
16-bit
Sampling frequency
44.1 kHz
See the included startup guide for operating procedures, including recording
and playback.
HINT
• You can balance the output and the computer output. (See page 25.)
• You can adjust the recording level. (See page 26.)
NOTE
To monitor the signal of your connected guitar after it has passed through your DAW software, set USB
AUDIO MONITOR balance to 100. (See page 25.)
At other settings, the output signal will sound like a flanger effect is being used.