User Manual
Table Of Contents
- Usage and safety precautions
- Introduction
- Terms used in this manual
- Part names
- Turning the power on
- Display information
- Adjusting effects
- Using the output booster
- Adjusting the master level
- Using patches
- Changing USB audio settings
- Changing various settings
- Using the tuner
- Using rhythms
- Using the looper
- Using the pedal
- Setting the tempo
- Setting how the TAP LED blinks
- Using as an audio interface
- Adjusting the pedal
- Restoring default settings and patches
- Updating the firmware
- Troubleshooting
- Rhythm List
- Specifications
51
Adjusting the pedal
Calibrating the sensitivity
• Turn the power switch ON while pressing .
• Operate the pedal as instructed on the display, and press when
required.
• "Complete!" will appear before play mode becomes active.
NOTE
Calibrate in the following cases.
– Stepping on the pedal has little effect.
– The volume and tone changes greatly even when the pedal is only pressed lightly.
Adjusting the torque
• Insert the hex key into the vertical torque adjustment screw on the side of
the pedal.
Turn it clockwise to tighten the pedal, and turn it counterclockwise to loosen
the pedal.
Loosen Tighten
NOTE
Be careful when loosening a torque adjustment screw, because if you loosen it too much, it could come off
inside the unit, making it impossible to hold the pedal in place.