Owner's manual

EQ (Equalizer) module
ZOOM GFX-3
19
[Table 1]
◆ EQ (Equalizer) module
This is a 4-band equalizer.
◆ MOD (Modulation) module
This module contains modulation type effects such as chorus and flanger, effects that drastically change the sound such as
wah, filter, and ring modulator, and pitch altering effects such as pitch shift and vibrato.
Setting Description Setting Description
oF
Turns the cabinet simulator off.
CM
Simulates a general type combo amp cabinet.
bo
Simulates a small amp cabinet.
CE
Simulates an EV speaker in a combo amp cabinet.
Zb
Simulates a cabinet with ZOOM's original sound character.
St
Simulates a stack amp cabinet.
bC
Simulates a bright combo amp cabinet.
SE
Simulates an EV speaker in a stack amp cabinet.
TYPE 11: ACOUSTIC ( AA
AA
CC
CC
)
CLASSIC ACFAT
STANDARD AC BRI
Changes the sound of an electric guitar to resemble an acoustic guitar. The CLASSIC and STANDARD settings give a different sound character.
Parameter 1
TOP Parameter 2 BODY
1 – 10 1 – 10
Adjusts characteristic acoustic guitar string sound. Adjusts body resonance.
Parameter 3
CABINET Parameter 4 LEVEL
oF, bo, Zb, bC, CM, CE, St, SE 1 – 8
Selects the cabinet type. Adjusts signal level after passing module.
Parameter 1
PRESENCE Parameter 2 TREBLE
-12 – 12 -12 – 12
Adjusts boost/cut in high range (center frequency 8 kHz). Adjusts boost/cut in mid-high range (center frequency 3.125 kHz).
Parameter 3 MIDDLE Parameter 4 BASS
-12 – 12 -12 – 12
Adjusts boost/cut in middle range (center frequency 8 kHz). Adjusts boost/cut in low range (center frequency 125 Hz).
TYPE 1: CHORUS ( CC
CC
HH
HH
)
Adds pulsation and spaciousness to the sound.
Parameter 1
COLOR Parameter 2 DEPTH
C1, C2 0 – 10
Selects the chorus character. C1 gives a modern stereo chorus, and C2 a
vintage chorus sound.
Adjusts modulation intensity.
Parameter 3
RATE Parameter 4 MIX
1 – 30 0 – 30
Adjusts modulation speed. Adjusts mixing balance of original sound and effect sound.
TYPE 2: FLANGE ( FF
FF
LL
LL
)
Produces a unique, undulating sound.
Parameter 1
COLOR Parameter 2 DEPTH
1 – 30 0 – 10
Sets the pre-delay. Adjusts modulation intensity.
Parameter 3
RATE Parameter 4 RESO
1 – 30 -10 – 10
Adjusts modulation speed.
Adjusts feedback ratio. Higher values in positive or negative direction
result in stronger characteristics.
En-GFX3.book 19 ページ ２００４年１１月８日 月曜日 午後４時３０分