User Manual

143
Reference / MTR mode eect types and parameters
MTR mode eect types and parameters
■ EFX modules
● Compressor/limiter eects
RackComp
Compressors reduce high-level signals and raise the
minimum level.
(1) THRSHOLD 0–50
Sets the base level from which the compressor
operates.
(2) RATIO 1–10
Sets the compression ratio.
(3) ATTACK 1–10
Sets how quickly compression starts.
(4) LEVEL 2–100
Sets the level of the signal after the EFX module.
LIMITER
Limiters compress when input signals exceed the xed
level.
(1) THRSHOLD 0–50
This sets the base level from which the limiter
operates.
(2) RATIO 1–10
Sets the compression ratio.
(3) RELEASE 1–10
Sets how quickly the limiter stops functioning
after the signal goes below the base level.
(4) LEVEL 2–100
Sets the level of the signal after the EFX module.
● Modulation eects
AUTO WAH
This wah eect responds to changes in input signal
strength.
(1) POSITION
Before,
After
Sets the insertion point of the EFX module.
Select before or after the PREAMP.
(2) SENSE
−10–−1,
1–10
Sets the eect sensitivity.
(3) RESONANC 0–10
Sets the amount of resonance.
(4) LEVEL 2–100
Sets the level of the signal after the EFX module.
PHASER This eect varies the sound with phasing.
(1) POSITION
Before,
After
Sets the insertion point of the EFX module.
Select before or after the PREAMP.
(2) RATE
0–50, ♪
(See P.146)
Adjusts the speed of modulation.
(3) COLOR
4STAGE,
8STAGE,
INVERT4,
INVERT8
Select the eect sound type.
(4) LEVEL 2–100
Sets the level of the signal after the EFX module.
TREMOLO This eect raises and lowers the volume cyclically.
(1) DEPTH 0–50
Adjusts the modulation depth.
(2) RATE
0–50, ♪
(See P.146)
Adjusts the speed of modulation.
(3) WAVE
UP 0–9
DOWN 0–9
TRI 0–9
Select the modulation waveform from UP (rising
sawtooth), DOWN (falling sawtooth) and TRI
(triangle) types.
The higher the number, the more the wave peaks
are clipped, emphasizing the eect.
(4) LEVEL 2–100
Sets the level of the signal after the EFX module.