Specifications

4-Track Mode
ZOOM H4
44
3.
Locate a point slightly before the
intended punch-in point, and press
the top (@
) of the [MENU] key.
4.
When you come to the punch-in
point, press the [REC] key.
The [REC] key lights up, and track recording
begins from that location (punch-in).
5.
When you come to the intended
punch-out point, press the [REC] key
once more.
The [REC] key goes out, and the H4 switches
from recording to playback (punch-out).
6.
Press the top (@ ) of the [MENU] key
to stop the recorder.
7.
To check the results, use the locate
function to move to a point before
the punch-in point, and press the top
(
@ ) of the [MENU] key.
◆ Auto punch-in/out
To automatically re-record only a part of an
audio track by specifying the punch-in/out points
beforehand, proceed as follows.
1.
At the top screen, press one of the
TRACK [1] – [4] keys to select the
track you want to re-record.
The display shows the number of the selected
track.
2.
Press the same TRACK [1] – [4] keys
that you pressed in step 1 repeatedly,
so that the key is lit in red.
The input signal can now be monitored. The
number of the track selected as recording target
is shown in reverse.
3.
Locate the intended punch-in point.
4.
Move the jog dial up/down to bring
the cursor to the A-PUNCH button.
Then press the jog dial.
The A-PUNCH button flashes, and the point is
set as the punch-in point where auto punch-in/out
will begin.
NOTE
In Always New mode, the A-PUNCH button is
grayed out and cannot be selected.
5.
Locate the intended punch-out point
and bring the cursor to the A-PUNCH
button. Then press the jog dial.
The A-PUNCH button changes from flashing to
reverse, and the point is set as the punch-out
point where auto punch-in/out will end. When
auto punch-in/out is enabled, the TRACK key(s)
will flash while the recorder is before the punch-
in point and after the punch-out point.
NOTE
•To redo the punch-in/out point setting, bring
the cursor to the A-PUNCH button and press
the jog dial to return the button indication to the
original condition. Then repeat steps 3 – 5.
Input
signal level
A
-PUNCH
button
H4_E.book 44 ページ ２００６年９月１日 金曜日 午後７時５６分