Operation Manual

84
SD card settings
Conducting a full test
1. Open MENU > SD CARD > PERFORMANCE TEST.
2. Use to select FULL TEST, and press .
The amount of time required will be shown.
3. Use to select YES, and press .
The result of the test will be shown when it completes.
If the access rate MAX reaches 100%, the card will fail (NG).
4. Press to stop the test.
You can press to pause and resume a test.
HINT
NOTE
Even if a performance test result is "OK", there is no guarantee that writing errors will not occur. This informa-
tion is just to provide guidance.