User manual
Table Of Contents
- Usage and Safety Precautions
- Names and functions of parts
- Equipment connection example
- Display overview
- Turning the unit on/off
- Using the MENU screen
- Mixer
- Recording and playback
- Using the metronome
- Using the slate mic
- Projects
- Audio files
- Using audio interface functions
- Using card reader functions
- Recording and playback settings
- SD card settings
- Various settings
- Troubleshooting
- Specifications
- Send effects specifications
- Mixer block diagram
- Usage and Safety Precautions
- Names and functions of parts
- Equipment connection example
- Display overview
- Turning the unit on/off
- Using the MENU screen
- Mixer
- Recording and playback
- Using the metronome
- Using the slate mic
- Projects
- Audio files
- Using audio interface functions
- Using card reader functions
- Recording and playback settings
- SD card settings
- Various settings
- Troubleshooting
- There is no sound or output is very quiet
- Recorded audio is too loud, too quiet or silent
- Recording not possible
- Playback sound cannot be heard or is quiet
- The sounds of devices connected to input jacks are distorted
- The send effect is not working
- There is no sound or output is very quiet from MONITOR OUT A–E
- Cannot select or use the L-12 device
- Sound skips during playback or recording
- Cannot play or record
- There is no sound or output is very quiet
- Specifications
- Send effects specifications
- Mixer block diagram
Adjusting the tone and panning
CHANNEL
STRIP section
SEL
button
1.
Press to light it for the channel for which you want to adjust tone and panning.
2.
Use the knobs and buttons in the channel strip section to adjust the tone and panning.
Adjusting the tone: , , , ,
Adjusting the panning:
NOTE
• Press
to light it, turning off all equalization at once. This will bypass HIGH, MID, LOW and LOW CUT
settings.
• Using the compressor (→ Input channel section)
HINT
Details about knobs and buttons (→ CHANNEL STRIP section)
32