User manual
Table Of Contents
- Usage and Safety Precautions
- Names and functions of parts
- Equipment connection example
- Display overview
- Turning the unit on/off
- Using the MENU screen
- Mixer
- Recording and playback
- Using the metronome
- Using the slate mic
- Projects
- Audio files
- Using audio interface functions
- Using card reader functions
- Recording and playback settings
- SD card settings
- Various settings
- Troubleshooting
- Specifications
- Send effects specifications
- Mixer block diagram
- Usage and Safety Precautions
- Names and functions of parts
- Equipment connection example
- Display overview
- Turning the unit on/off
- Using the MENU screen
- Mixer
- Recording and playback
- Using the metronome
- Using the slate mic
- Projects
- Audio files
- Using audio interface functions
- Using card reader functions
- Recording and playback settings
- SD card settings
- Various settings
- Troubleshooting
- There is no sound or output is very quiet
- Recorded audio is too loud, too quiet or silent
- Recording not possible
- Playback sound cannot be heard or is quiet
- The sounds of devices connected to input jacks are distorted
- The send effect is not working
- There is no sound or output is very quiet from MONITOR OUT A–E
- Cannot select or use the L-12 device
- Sound skips during playback or recording
- Cannot play or record
- There is no sound or output is very quiet
- Specifications
- Send effects specifications
- Mixer block diagram
Conducting a full test
1.
Open MENU > SD CARD > PERFORMANCE TEST.
2.
Use to select FULL TEST, and press .
The amount of time required will be shown.
3.
Use to select YES, and press .
The result of the test will be shown when it completes.
If the access rate MAX reaches 100%, the card will fail (NG).
4.
Press to stop the test.
HINT
You can press to pause and resume a test.
NOTE
Even if a performance test result is "OK", there is no guarantee that writing errors will not occur. This
information is just to provide guidance.
87