User Manual

3
MONITOR OUT A–F knobs
Use to adjust the volumes of the signals output from the MONITOR OUT A–F jacks.
4
MONITOR OUT A–F switches
These switch the signals output from the MONITOR OUT A–F jacks.
Status Explanation
MASTER ( ) The signal after adjustment by the master fader will be output.
A–F ( ) The signals set in the FADER MODE section are output.
5
MONITOR OUT A–F PHONES/SPEAKER switches
Use these to select the type of equipment connected to the MONITOR OUT A–F jacks.
Status Explanation
( )
Select this when headphones are connected. A stereo signal is output from the
MONITOR OUT A–F jack.
( )
Select this when speakers are connected. A mono balanced signal is output from
the MONITOR OUT A–F jack.
6
SELECT knob
Use this to select the signal output from the PHONES jack.
The options are MASTER, SOLO and MONITOR OUT A–F.
Status Explanation
MASTER The same signals as the MASTER OUT are output.
A-F The signals set in the FADER MODE section are output.
SOLO The signals of SOLO enabled channels are output.
NOTE
When a SOLO button is activated, this knob will also automatically select SOLO. At such times, changing
the output with the SELECT knob will cancel soloing.
7
VOLUME knob
Use this to adjust the volume of the PHONES jack.
8
PHONES jack
Connect headphones here.
9
MASTER REC/PLAY button
Use this button to switch between recording the signal input on the master bus to the SD card and play-
ing back an already recorded le from the SD card.
Status Explanation
Lit red The signal will be recorded to the SD card after adjustment by the master fader.
Lit green
The playback signal of a le is inserted on the master bus. The REC/PLAY buttons
of other channels will be unlit at this time.
Unlit Files will neither be recorded nor played back.
!
MASTER MUTE button
This mutes or unmutes the MASTER OUT jacks. To mute the channel, press this button to light it.
"
Master level meters
These show the signal levels output from the MASTER OUT jacks in a range from −48 dB to 0 dB.
15