User Manual
Rear panel
1
POWER switch
2
DC IN 12V AC adapter connector
3
USB HOST port
4
MODE switch
5
USB DEVICE port
6
CLASS COMPLIANT MODE
switch
7
SAMPLE RATE switch
8
SD card slot
9
CONTROL IN jack
!
REMOTE jack
1
POWER switch
This turns the unit on and off.
Switch to — to turn the power on. Switch to to turn the power off.
When the POWER switch setting is changed to OFF, the current mixer settings are automatically saved
in the unit and in the settings le in the project folder on the SD card.
2
DC IN 12V AC adapter connector
Connect the included AC adapter here.
3
USB HOST port
This USB 2.0 HOST port is for connecting USB ash drives.
Projects and audio les can be saved on and loaded from connected USB ash drives.
4
MODE switch
Set whether to use as a USB HOST, card reader or audio interface.
This cannot be changed after starting up.
5
USB DEVICE port
This USB 2.0 port is for connecting with a computer.
It will start up as a card reader or audio interface, depending on the MODE switch selection.
Card reader mode
Operating as an SD card reader, data can be exchanged with a computer.
Audio interface mode
Operating as an audio interface, audio data can be exchanged with a computer.
Inputs: The signals from channels 1–20 after they pass through their compressors and the master fader
output signals are input to the computer.
Outputs: Outputs from the computer can be assigned to channels 17/18 and 19/20.
Use when connected to an iOS device is possible if the CLASS COMPLIANT MODE switch is set to ON.
19