User Manual

Turn it on ( ) when connecting a guitar or bass guitar.

PAD switch

This attenuates (reduces) the input signal of the equipment connected to the MIC/LINE input jack by 26

dB.

Turn this on ( ) when connecting line level equipment.

SIG indicator

This indicator shows the signal level after adjustment by the GAIN knob.

The indicator color changes according to the signal level. Adjust so that it does not light red.

Lit red: Lit red: input signal level is close (−3 dBFS or higher) to the clipping level (0 dBFS)

Lit green: Lit green: input signal level is between −48 dBFS and −3 dBFS compared to the clipping level

(0 dBFS)

GAIN knob

Use to adjust the input gain of the mic preamp.

The range of adjustment depends on the on/off status of the MIC/LINE input jack switch (Hi-Z on chan-

nels 1–2 or PAD on channels 3–16).

Jack Adjustment range

MIC/LINE input jack 1–2 (XLR) +16 – +60 dB

MIC/LINE input jack 1–2 (TRS)

Hi-Z off +16 – +60 dB

Hi-Z on (TS) +6 – +50 dB

MIC/LINE input jack 3–16

PAD off +16 – +60 dB

PAD on −10 – +34 dB

COMP knob

Use to adjust the amount of compression.

SEL button

Use to select a channel for parameter adjustment in the channel strip section.

Channels with lit SEL buttons are affected by channel strip section adjustments.

REC/PLAY button

Use this button to switch between recording input signals to the SD card and playing back an already

recorded le from the SD card.

Status Explanation

Lit red Input signals will be recorded to the SD card.

Lit green

An already recorded le will be played back. Playback signals are input

before the equalizer. In this state, only files are played back. Signals

from input jacks are disabled.

Unlit Files will neither be recorded nor played back.

NOTE

Recorded signals can be set to either before or after the compressor. (→ "Changing the input signal re-

cording source")