User Manual
Changing the sampling rate
The le format used when recording to the recorder depends on this setting.
Before changing the sampling rate, must be set to OFF.
1.
Conrm that is set to OFF.
2.
Change the position.
HINT
This can be set to 44.1 kHz, 48 kHz or 96 kHz.
NOTE
• Format an SD card before recording to it at 96 kHz. If you record without formatting rst, skipping could
occur.
• When 96 kHz is selected, some unit operations are limited. The limited functions are as follows.
- SEND EFX 1/2: disabled
- EQ: disabled
- OVER DUB: disabled
- Audio interface: disabled
- MONITOR OUT: output signal same as MASTER only
3.
Set to ON.
NOTE
• The sampling rate cannot be changed during operation.
• If a project is loaded that has a different sampling rate than the unit setting, recording and playback will
not be possible.
90