Operator`s manual

Service
For questions regarding operation or r
epair of the PRM or ZWT, contact Boston
Scientific using the information on the back cover. The PRM and ZWT must be
serviced by Boston Sci entific personnel only.
If the PRM or ZWT malfunction and requi re repair, help to ensure efficient
service by following these guideline s:
1. Leave the configuration of the instrument exactly as it was at the time
of malfunction. Contact Boston Scientifi c using the information on the
back cover.
2. Write a detailed description of the malfunction(s).
3. Save printouts or othe r materials that illustrate the prob lem.
4. If the PRM or ZWT must b e returned to
Boston Scientific for service,
pack it in the shipping container in which it was rece ived or in a s hipping
container provided by Boston Scientific.
5. For the shipping address, contact Boston Scientific using the information
on the back cover.
For problems or que stions that arise reg arding operation or repair of the
optional external printer, contact the printer manufacturer or agent.
HANDLING
Tr oubleshooting
If the PRM or ZWT does not operate properl y, check that electrical cords and
cables are secure ly connected and that cords and cables are in good working
order (i.e., free of visible defects). Possible causes and corrective actions for
problems are show n below. For external printer problems, refer to the manual
for the external printer.
Table 2. Possible causes and corrective actions for PRM problems
Symptom Possible Cause Corrective Action
No AC line voltage
Check that the power cord is
plugged se curely into the rear
panel of the PRM.
Change to a different electrical
outlet.
Paper jam
Open the printer door and use
clean fin gertips to both remove
the paper and r otate the roller in
a clockwise direction.
Internal
printer/recorder does
not function
No paper Add paper.
Paper misaligned Reload paper.
Internal
printer/recorder: pa-
per-feed problems
Paper-feed obstruction
Clear obstruction from aro und
the paper supply.
27