Operation Manual

Reference [Rhythm]
ZOOM MRS-1608
109
1
Measure
3245
PATTERN 001 PATTERN 020
D maj G min A7
BPM-135
10
10
0
0
4/4
Pattern
Beat
Root/chord
Tempo
Drum track volume
Bass track volume
Drum kit number
Bass program number
in the same way as described in steps 3 – 6.
You can move the input location within a rhythm song in
the following ways.
● Moving in steps of a measure
Use the cursor left/right keys to move to the beginning of
the preceding or following measure.
●
Moving in steps of a beat
Use the REW [
T
]/FF [
Y
] keys to move to the beginning
of the preceding or following beat.
●
Moving in steps of a sixteenth note
Repeatedly press the cursor up key to bring up the
indication “EV
→
” on the display, and turn the dial to
move forward or backward in 12-tick (16th note) units.
If necessary, you can also input chord information at a
point within a measure, as shown below (smallest unit:
sixteenth note). For example, to enter chord information
in sixteenth note units, bring up the indication “EV
→
” on
the first line of the display, turn the dial to move current
point, and then bring up the chord information input
screen again.
HINT
At a point where no chord information is input, “ ” is
shown to the left of the “ROOT” or “CHORD” indication. This
means that the immediately preceding information continues
to be valid.
8. Input the remaining chord data in the same
way.
If you have made a mistake or want to make a change,
proceed as follows.
●
To change chord information
Move to the location at which the chord data is input, use
the cursor up/down keys to switch the display to “ROOT”
or “CHORD”, and turn the dial to change the chord
information.
●
To delete chord information
Move to the location at which the chord data is input, use
the cursor up/down keys to switch the display to “ROOT”
or “CHORD”, and press the [DELETE/ERASE] key. The
chord data (root and chord) will be deleted, and the
display will change to “ ROOT” or “ CHORD”.
9.
When you have finished, press the STOP
[
P
] key.
The unit returns to the rhythm song selection screen. By
pressing the PLAY [
R
] key in this condition, you can
check the rhythm song with the new chord information.
To return to the main screen, press the [EXIT] key several
times.
Entering other information
A rhythm song contains information about rhythm
patterns, chord, tempo, beat etc. in a matrix
configuration, as shown at the bottom of this page. This is
called event information. When the rhythm song is in the
input condition (REC [O ] key lit), you can move the
current position with the cursor keys etc. and use the
cursor up/down keys to call up and enter or edit event
information.
1. Verify that the [SONG] key and [RHYTHM]
key are lit.
Measure
Beat
1 2341234
1
Em
3
Em
2
Am
4
AmB7
PATTERN A
1 2341234
PATTERN B
1608E.book 109 ページ ２００４年４月１９日 月曜日 午前１０時４４分