Operation Manual

ZOOM MRS-1608
138
REC LEVEL
DRUM BASS 1 2 13/14 15/16
REVERB
Send/return effect
CHORUS/DELAY
REVERB SEND
CHORUS/DELAY SEND
Track mixerInput mixer
Send/return effect
Track 15/16
Track13/14
Track 2
Track 1
BASS
DRUM
Track mixer
Recorder
section
Rhythm
section
Input mixer
In point
Insert effect
(1)
Insert effect
OUTPUT
MASTER
(2)
(3)
Reference [Effects]
This section explains the functions and operation of the effect section built into the MRS-1608.
The MRS-1608 has two types of effects, an “insert effect”
and a “send/return effect”. The two types can be used
simultaneously. The characteristics of these effects are
described below.
Insert effect
The insert effect is used by inserting it into a specific point
in the signal route. You can select one of the following
locations at which to apply the effect.
(1) Input mixer
(2) Any track of the track mixer
(3) Immediately before the [MASTER] fader
For example, if you insert the effect into the input mixer, the
input signal is processed by the effect and the result is
recorded on a track of the recorder. Alternatively, if you
insert the effect into a channel of the track mixer, the effect
processes the playback signal from an audio track or the
drum/bass track.
By selecting a position immediately before the [MASTER]
fader, you can use the effect to process the final mix before
recording on the master track.
Send/return effect
The send/return effect is internally connected to the send/
return loop of the mixer section. The MRS-1608 has two
types of send/return effects, reverb and chorus/delay, and
these two can be used simultaneously.
The send levels of the input mixer or track mixer adjust the
effect depth of the send/return effect. Raising the send level
will send the corresponding signal to the input of the effect,
and the signal processed by the effect will be returned
immediately before the [MASTER] fader, and mixed with
the other signals.
About the effects
1608E.book 138 ページ ２００４年４月１９日 月曜日 午前１０時４４分