Operation Manual

Reference [Effects]
ZOOM MRS-1608
139
COMP
PRE AMP/DRIVE MODULATION/DELAYZNR EQ
VOL PDL
COMP/LIM
ISOLATOR MODULATIONZNR EQ
VOL PDL
3BAND COMP
LO-FI
NORMALIZE
DIMENSION
RESONANCE
ZNR EQ
VOL PDL
COMP/LIM
MIC PRE+DE-ESSER MODULATION/DELAYZNR EQ
VOL PDL
COMP/LIM
MIC PRE DELAYZNR EQ
VOL PDL
COMP/LIM
MIC PRE DELAYZNR EQ
HPF
EQ
VOL PDL
HPF
EQ
HPF
COMP/LIM
COMP/LIM
COMP/LIM
EQ
LINE
MASTERING
CLEAN
DIST
ACO/BASS SIM
BASS
MIC
DUAL MIC
8x
COMP EQ
Effect module arrangement
Input/output type
Algorithm
Mono Stereo
Mono x 2
Mono x 2
Mono x 8
Mono x 8
* VOL PDL applies to
all inputs
Stereo Stereo
x 8 x 8 x 8
This section explains how to select the position for the insert
effect, how to select a patch, and how to edit the patch.
About insert effect patches
The insert effect is a multi-effect unit that contains a number
of single effects such as compressor, distortion, and delay,
connected in series. Each of these separate effects is called
an “effect module”.
A combination of effect modules that can be used
simultaneously is called an “algorithm”.
The MRS-1608 offers the following algorithms.
CLEAN
DIST
ACO/BASS SIM
BASS
An algorithm suitable for recording guitar/bass.
MIC
An algorithm suitable for microphone recording of vocals
etc.
DUAL MIC
An algorithm with two entirely separate channels for mono
input x 2 and mono output x 2.
8x COMP EQ
This is an algorithm with eight separate inputs/outputs.
Separate high-pass filter (HPF), compressor, and EQ settings
are possible for each channel.
LINE
An algorithm suitable for recording line-level output
instruments such as synthesizer or electric piano.
MASTERING
An algorithm suitable for processing the final stereo mix
signal.
The arrangement of effect modules and the signal flow for
each algorithm is shown in the diagram below.
HINT
Depending on the selected algorithm, the input/output
configuration of the effect will differ. For some insert position
settings, two input signals or the stereo output of an effect
may be mixed to mono (
p. 141).
With the 8x COMP EQ algorithm, the VOL PDL module is
shared by all eight channels.
Each effect module comprises two aspects, namely the effect
type and the effect parameters. Effect type and parameter
settings for an effect module are collectively referred to as a
“patch”.
Using the insert effect
1608E.book 139 ページ 2004年4月19日 月曜日 午前10時44分