Operation Manual

Reference [Creating a CD]
ZOOM MRS-1608
156
[MARK] key again, you can return to the previous
condition. The marker enable/disable selection can be
made at any time while the album screen is shown.
If the mark function is enabled for the project registered
as track 1 of the audio CD, the following indication
appears.
When you divide a project, the number of tracks on the
album will increase, and tracks corresponding to
subsequent projects will be renumbered.
For example four marks are set for the project, the tracks
on the audio CD will be allocated as follows.
The subsequent steps for creating the audio CD are as
described in the previous section.
NOTE
• If the tracks have not been separated as expected, press the
[EXIT] key repeatedly to return to the main screen, and check
whether marker information has been created properly for the
project.
• If marks are too close together, the indication “ERROR Track
is Short” appears on the display, and marker-based
separation cannot be enabled for that project.
• The maximum number of tracks per album is 99. If you
attempt to enable marker-based separation for a project and
this causes the number of tracks to exceed 99, the indication
“ERROR Too Many Track” appears, and marker-based
separation cannot be enabled.
Including a playlist in an album
The MRS-1608 lets you register the master tracks of
multiple projects in a list (playlist) for continuous
playback in a sequence ( → p. 177). It is possible to include
playlist information when creating an audio CD by album.
HINT
You can create up to ten playlists, but only one can be
included in an album.
1. Perform steps 1 – 6 of “Creating an audio
CD by album”, and bring up the album
screen on the display.
2.
Press the [UTILITY/TRACK EDIT] key in the
display section.
The display indication changes as follows. In this
condition, you can select the playlist (1 – 10) to include
in the album.
3. Turn the dial to select the playlist, and press
the [ENTER] key.
The indication “IMPORT SURE?” appears on the display.
4. To import the playlist information, press the
[ENTER] key.
The procedure is carried out, and the album screen returns.
HINT
After importing playlist information, you can edit the album
as normal.
PRJ 001
PRJ 001
PROJ001
PROJ001
Track 1
Track 1
0 4
4
36
36
120
120
PQ
PQ
Project 1 (marker-based separation
enabled)
Project 2 (marker-based
separation disabled)
A
udio CD
track
numbers
Track 1 Track 2 Track 3 Track 4 Track 5
END OF
END OF
ALBUM
ALBUM
Track 1
Track 1
0 0
0
0
0
0
0
IMPORT
IMPORT
PlayList
PlayList
LIST 1
LIST 1
Playlist number
IMPORT
IMPORT
SURE?
SURE?
1608E.book 156 ページ ２００４年４月１９日 月曜日 午前１０時４４分