Operation Manual
Reference [Recorder]
ZOOM MRS-1608
39
HINT
You can also use the cursor up/down keys to change the
scrub playback length.
3.
To change the direction of scrub playback,
use the cursor left/right keys to cause the
scrub playback direction indication to
flash, and turn the dial.
If you select “TO”, scrub playback will begin from an
earlier point and end at the current location. If you select
“FRM”, scrub playback will begin from the current
location.
To exit the scrub function, press the STOP [
P
] key.
Punch-in/out is a function that lets you re-record just a
specified region of a previously recorded track. The action
of switching a currently-playing track to record mode is
called “punch-in”, and the action of switching back from
recording to playback is called “punch-out”.
The MRS-1608 provides two ways to do this. You can use
the panel keys or a foot switch (ZOOM FS-01, sold
separately) to punch-in/out manually (“manual punch-in/
out”), or you can cause punch-in/out to occur automatically
at previously specified points (“auto punch-in/out”).
NOTE
When the 8-track recording function (
→
p. 45) is active,
punch-in/out cannot be used.
Using manual punch-in/out
To perform manual punch-in/out, proceed as follows.
HINT
•To use a foot switch for punch-in/out, connect the
separately available ZOOM FS-01 to the FOOT SW jack on
the front panel.
• In the default condition of the MRS-1608, the foot switch
is set to control recorder playback/stop. To use the foot
switch to punch-in/out, you must first change the foot
switch setting (
→
p. 181).
1.
Repeatedly press the status key of the
track on which you want to perform punch-
in/out, until the key is lit in red.
2.
Raise the fader of this track to a suitable
position.
3.
Use the [ON/OFF] key to select the input,
and then play your instrument connected to
the INPUT jack and use the [INPUT] control
and [REC LEVEL] control to adjust the
recording level.
4.
Locate a point several measures before the
intended punch-in point, and press the
PLAY [
R
] key to begin recorder playback.
5.
When you come to the punch-in point,
press the REC [
O
] key (or press the foot
switch).
The REC [
O
] key lights up, and track recording begins
from that location.
6.
When you come to the intended punch-out
point, press the REC [
O
] key (or the foot
switch) once more.
The REC [
O
] key goes out, and the MRS-1608 switches
from recording to playback.
7.
To stop the recorder, press the STOP [P
]
key.
8.
To check the newly recorded content,
locate to a point before the punch-in point,
and press the PLAY [R
] key.
Re-recording only a specified
region (punch-in/out function)
Current location
Scrub playback
(default setting)
Current location
Scrub playback
1608E.book 39 ページ ２００４年４月１９日 月曜日 午前１０時４４分