Operation Manual

Reference [Track Editing]
ZOOM MRS-1608
59
9.
Press the cursor down key to cause the
counter indication to flash. Then use the
cursor left/right keys and the dial to specify
the start point for harmony generation.
You can also use the MARKER [U ]/[I ] keys, ZERO
[U ] key, and REW [T ]/FF [Y ] keys to locate the point.
HINT
The manual and automatic punch-in/punch-out functions
can also be used at this point.
10 . To start harmony generation, hold down the
REC [O ] key and press the PLAY [R ] key.
Recording starts. The display indication changes as
follows.
When the second line of the display reads “CHORD”, the
chord of the current rhythm pattern/rhythm song is
shown. By using the cursor left/right keys, you can
display and edit the parameters of steps 5 – 8.
HINT
When playing the harmony, the drum/bass track will also be
played. Use the faders as required to adjust the level.
11.
When recording has progressed to the
point where you want harmony generation
to stop, press the STOP [
P
] key.
The indication “HARMONY+ SURE?” appears on the
display.
12.
To carry out harmony generation, press the
[ENTER] key.
The audio data of the specified range are written. When
the process is complete, the unit returns to the track edit
menu.
By pressing the [EXIT] key instead of the [ENTER] key,
you can cancel the operation and back up one step at a
time.
Generating a 1-part harmony from
a specified range of audio data
You can specify a KEY and SCALE and shift the pitch of
the audio data by a third up or down to create a 1-part
harmony. This is called the Duo Harmony function.
The pitch-shifted audio data can be either added to the
source material or written to another track/V-take.
For example, when KEY = C and SCALE = Major is
specified, and shift upwards is selected for the Duo
Harmony function, the following harmony will be
created.
NOTE
For the Duo Harmony function to work properly, the audio
data should represent single notes recorded without
applying delay, reverb, chorus, or other effects.
1.
Refer to steps 1 - 6 of “Basic steps for
range editing” to select the track/V-take for
harmony generation, and press the
[ENTER] key.
The indication “DHmnyDst” appears on the display. In
this condition, you can select the target destination for
writing the created harmony.
NOTE
You can only select a single mono track or one track of a
stereo pair as source track for Duo Harmony.
HARMONY+
HARMONY+
CHORD
CHORD
C Maj
C Maj
0 0
0
12
12
910
910
007
007
44
44
6
6
00
00
Source track
KEY/SCALE = C Maj
Write target track
Duo Harmony
DHmnyDst
DHmnyDst
TR 1- 1
TR 1- 1
1608E.book 59 ページ ２００４年４月１９日 月曜日 午前１０時４４分