Specifications

Reference [Effects]
ZOOM MRS-1608
145
Storing/swapping insert effect
patches
A patch that you have edited can be stored in any location of
the same algorithm. You can also store an existing patch in
another location to create a copy of that patch. Interchanging
the position of patches (swapping) is also possible.
1. At the insert effect patch select screen, press
the [STORE] key.
The currently selected patch goes into the store standby
condition. In this condition, you can perform the store or
swap operation.
2. Use the cursor left/right keys to bring up the
indication “STORE TO” or “SWAP TO”.
3. Turn the dial to select the number of the patch
to store/swap.
4. To carry out the store/swap operation, press
the [STORE] key.
When the store/swap operation is completed, the insert
effect patch select screen appears again.
By pressing the [EXIT] key instead of the [STORE] key, you
can cancel the operation and back up one step at a time.
HINT
• Patches that you have stored are saved on the hard disk as
part of the project.
• Patch data included in an already existing project can be
loaded into the current project (
→
p. 149).
Editing the name of an insert
effect patch
This section explains how to edit the name of the currently
selected patch.
1. Use the [ALGORITHM] keys to select the
algorithm which contains the patch whose
name you want to change. Then use the
PATCH SELECT [W
]/[Q ] keys or the dial to
select the patch.
2. Press the [EDIT] key.
The currently selected patch can be edited.
3. Use the cursor left/right keys to bring up the
indication “TOTAL PAT LVL” on the display.
4. Repeatedly press the cursor down key to
bring up the indication “PAT NAME” on the
display.
The name of the selected patch can now be edited.
The flashing section indicates the character that can be
changed.
5. Use the cursor left/right keys to move the
flashing section, and turn the dial to select a
character.
For information on available characters, refer to page 36.
6. Repeat step 5 as necessary to complete the
new name.
7. To confirm the new name, press the [STORE]
key in the control section twice.
The patch is stored under the new name, and the insert effect
patch select screen appears again.
NOTE
Keep in mind that the name will revert to the previous name if
you switch to another patch without storing the edited patch
name.
STORE TO
STORE TO
Standard
Standard
No.0
No.0
Patch number
TOTAL
TOTAL
PAT LVL
PAT LVL
25
25
PAT NAME
PAT NAME
Standard
Standard
1608E.book 145 ページ ２００４年４月１９日 月曜日 午前１０時４４分