Specifications

ZOOM MRS-1608
17
Blank panel
Front Panel
Installing the CD-R/RW Drive
To install the separately available CD-R/RW drive into the MRS-1608 model without preinstalled CD-R/RW drive,
proceed as follows.
Before installing the drive, make sure that all cables and the AC adapter are disconnected.
1. Turn the MRS-1608 over and remove the blank panel
from the drive mounting section of the front panel.
To remove the blank panel, pull out the groove in the center.
2.
Remove the fastening screws of the bottom plate,
and remove the bottom plate.
Slide the bottom plate towards the rear to remove. Take care not to
lose the screws, as these will be needed again for reassembly.
3. Turn the CD-R/RW drive over and insert it into the
drive mount bay.
1608E.book 17 ページ ２００４年４月１９日 月曜日 午前１０時４４分