Specifications

Reference [Other Functions]
ZOOM MRS-1608
184
5.
To cancel the UIB mode at the MRS-1608,
press the [EXIT] key.
The indication “HDD scan...” is shown, and the MRS-
1608 returns to normal mode.
HINT
It is also possible to set the MRS-1608 to the on-line state
when turning the unit on. Hold down the [USB] key while
turning power to the MRS-1608 on. When you press the
[ENTER] key, the MRS-1608 and computer will be in the on-
line state (“I/F WORKING” is shown). To start up in normal
mode, cancel the on-line state and press the [EXIT] key.
This section describes how to test and restore the integrity
of data on the internal hard disk, and how to perform
other hard disk maintenance functions.
Basic maintenance procedure
The procedure for hard disk maintenance is the same for
most operations. The basic steps are described below.
1. Turn power to the MRS-1608 off. While
holding down the [CLEAR] key, turn power
on again.
The MRS-1608 starts up in “ROM utility mode” which
serves for performing special functions.
2.
Press the [MARK] key in the control
section.
The indication “ExtFunc Select” appears on the display.
3. Use the cursor left/right keys to select the
desired command.
The following commands are available.
●
ScanDisk
Test and repair the integrity of data stored on the internal
hard disk.
●
Init Fac (Factory Initialize)
Restore system files and various data necessary for
operation. Data created by the user will not be erased.
●
Init ALL (All Initialize)
Format the hard disk and restore system files and various
data necessary for operation. All existing projects will be
erased.
4.
Press the [ENTER] key to execute the
command.
Subsequent display indications and operation steps differ
for the individual commands. See the respective section
below.
5.
When the command has been executed,
turn the unit off and then turn it on again.
The MRS-1608 will operate in normal mode.
Test/restore integrity of data on
internal hard disk (ScanDisk)
This action serves to test and restore data on the internal
hard disk. Perform this procedure when operation of the
MRS-1608 has become unstable.
NOTE
ScanDisk may not be able in all cases to restore damaged
files. To guard against data loss, it is recommended to
regularly back up data from the hard disk onto CD-R/RW
discs.
1. Refer to steps 1 – 3 of “Basic maintenance
procedure” to bring up the indication
“ScanDisk” on the display. Then press the
[ENTER] key.
The ScanDisk menu for selecting the testing method
appears.
Hard disk maintenance
ROM UTY
ROM UTY
MRS-1608
MRS-1608
ExtFunc
ExtFunc
Select
Select
å
AutoRepr
AutoRepr
åENT
ENT
1608E.book 184 ページ ２００４年４月１９日 月曜日 午前１０時４４分