Specifications

ZOOM MRS-1608
19
Power On/Off
This section explains the procedure for turning the MRS-1608 on and off.
1.
Make sure that the MRS-1608 and
peripheral equipment is turned off.
2. Make sure that AC adapter, instrument, and
monitor system (or headphones) are
correctly connected to the MRS-1608. (For
information on connections, refer to page
15.)
At this time, the volume setting of the connected
instrument and monitor system should be minimum.
When a synthesizer or other electronic instrument is
connected, turn power to that device on before the MRS-
1608.
3. Press the [POWER] switch on the rear
panel.
Power to the MRS-1608 comes on, the unit performs a
self-test, and system settings are read. Wait until the
following indication appears on the display. This is called
the “main screen”.
4.
Turn on the connected monitor system.
1.
Turn power to the monitor system off.
2. Press the [POWER] switch on the rear
panel of the MRS-1608.
The indication “GOODBYE SEE YOU!” appears on the
display, and the unit is turned off.
When a synthesizer or other electronic instrument is
connected, turn power to that device off after the MRS-
1608.
•You must use this method to turn off
the power of the MRS-1608. Never turn
off the power by disconnecting the AC
adaptor plug from the [DC 12V] jack or
by unplugging the AC adaptor from the
AC power outlet.
• In particular, you must never turn the
power off by unplugging the AC
adaptor while the HDD ACCESS
indicator is lit. Doing so may damage
the internal hard disk, causing all data
to be lost permanently.
Turning power on
PRJ 000
PRJ 000
DontLkBk
DontLkBk
0 0
0
0
0
0
0
Turning power off
(shutdown)
1608E.book 19 ページ ２００４年４月１９日 月曜日 午前１０時４４分