User's Manual

Reference [Effects]
ZOOM MRS-8
100
Using the send/return
effect
This section explains how to select and edit patches for
the send/return effect.
The send/return effect of the MRS-8 is a single effect
module for which one effect type (reverb, chorus, delay,
etc.) can be selected.
Each effect type has various effect parameters which can
be adjusted to control the sound produced by the effect.
Such settings can be assigned a name and stored as a
patch. In the default condition, a project has 60 send/
return effect patches (40 of which are preprogrammed).
By selecting one of these, the send/return effect can be
instantly switched.
This section explains how to select a send/return effect
patch.
1.
From the main screen, press the [SEND/
RETURN] key in the effect section
repeatedly, until the key is lit.
The send/return effect patch selection screen appears.
2.
Turn the dial to select the patch.
As you turn the dial, new patches will be recalled
immediately. If the send/return effect send level for each
track has been raised, you can press the PLAY [
R
] key to
play back the song and check out the result of the newly
selected patch.
HINT
•You can also use the cursor left/right keys to adjust the EFX
LVL parameter (the mix amount of the effect sound).
• For information on how to adjust the send level, see page 59.
3.
To temporarily turn off the send/return
effect, press the [SEND/RETURN] key so
that the key goes out.
The send/return effect is switched to the bypass (off)
condition. The indication “SEND -MUTE-” is shown on
the display. To turn the send/return effect on again, press
the [SEND/RETURN] key once more.
4.
Press the [EXIT] key to return to the main
screen.
This section explains how to edit a send/return effect
patch.
1.
From the main screen, press the [SEND/
RETURN] key in the effect section
repeatedly, until the key is lit.
The send/return effect patch selection screen appears.
2.
Turn the dial to select the patch to edit.
HINT
If the indication “EMPTY” is shown in the patch name field,
all of the modules are set to off. By editing such a patch, you
can create it from scratch.
3.
Press the [EDIT] key.
The currently selected effect type appears on the second
line of the display.
The indication “EDIT” is shown on the display during
patch editing.
About the send/return effect
patches
Selecting a send/return effect
patch
SEND
SEND
VoChorus
VoChorus
0
Patch name Patch number
Editing a send/return effect
patch
SEND
SEND
VoChorus
VoChorus
0
TYPE
TYPE
HALL
HALL
Effect type
MRS-8(E).book 100 ページ ２００４年７月３０日 金曜日 午後５時２４分