User's Manual

Reference [Effects]
ZOOM MRS-8
101
4.
Turn the dial to switch the effect type.
When the effect type is changed, the effect parameters
will also change accordingly.
HINT
• If the contents of a patch have been changed, the “EDIT”
indicator in the upper part of the display will change to
“EDITED”. When the setting is returned to the original
condition, the indicator reverts to “EDIT”.
• By pressing the [ENTER] key during editing, you can
temporarily turn the effect off, which is convenient during
parameter adjustment. To turn the effect back on, press the
[ENTER] key once more.
5.
Use the cursor up/down keys to select the
effect parameter to edit.
The first line of the display shows the effect type, and the
second line shows the name and current value of the
effect parameter.
HINT
To change the effect type, press the cursor up key repeatedly
to bring up the indication of step 3, and then turn the dial.
6.
Turn the dial to change the setting.
For details on the effect types and effect parameters for
the send/return effect, refer to the appendix at the end of
this manual.
7.
To compare the sound of the currently
edited patch before and after editing, press
the [SEND/RETURN] key.
Pressing the [SEND/RETURN] key during editing
activates the compare function.
While the compare function is active, the display changes
as follows and the patch reverts to the last stored
condition.
To return to the edited patch, press the [SEND/RETURN]
key once more, or press the [EXIT] key.
8.
Repeat steps 5 – 6 as necessary to edit
other effect parameters.
9.
When you have finished editing, press the
[EXIT] key.
The send/return effect patch selection screen appears
again.
NOTE
Keep in mind that if you select another patch without first
storing the edited patch, the changes will be lost. For
information on how to store a patch, refer to the next section.
A patch that you have edited can be stored in any location
of the send/return effect. By storing an existing patch in
another location, you can create a copy of that patch.
Interchanging the position of patches (swapping) is also
possible.
1.
From the send/return effect patch selection
screen or edit screen, press the
[FUNCTION] key.
The currently selected patch goes into store standby
mode. In this condition, you can select whether to
perform store or swap.
2.
Use the cursor left/right keys to bring up
the indication “STORE TO” or “SWAP TO”.
3.
Turn the dial to select the number of the
patch to store/swap.
When carrying out store, the current patch settings will be
stored under this number.
When carrying out swap, the currently selected patch and
the patch settings selected here will be interchanged.
HALL
HALL
PRE DLY
PRE DLY
5
Effect parameter Setting value
COMPARE
COMPARE
VoChorus
VoChorus
0
Storing or swapping send/
return effect patches
STORE TO
STORE TO
VoChorus
VoChorus
0
Patch numbe
r
MRS-8(E).book 101 ページ ２００４年７月３０日 金曜日 午後５時２４分