User's Manual
Reference [Effects]
ZOOM MRS-8
103
3.
Turn the dial to select ALL (import all
patches) or PATCH (import single patch),
and press the [ENTER] key.
In this condition, you can select the project from which to
import.
4.
Turn the dial to select the import source
project, and press the [ENTER] key.
The subsequent steps differ, depending on which
selection was made in step 3.
• When ALL was selected
Verify that the indication “IMPORT SURE?” is shown on
the display and proceed to step 5.
• When PATCH was selected
The import source patch appears on the display. When
you turn the dial to select the patch and press the
[ENTER] key, the import target patch selected in step 1 is
shown. If necessary, turn the dial to select the number of
the patch to use as import target, and press the [ENTER]
key. The indication “SURE?” appears on the display.
5.
To carry out the import process, press the
[ENTER] key.
All patches or the specified patch of the selected project
will be imported. When the process is completed, the
display of step 1 appears again.
By pressing the [EXIT] key instead of the [ENTER] key,
you can cancel the operation and back up one step at a
time.
IMPORT
IMPORT
ALL
ALL
IMPORT
IMPORT
PRJ005
PRJ005
5
Project name Project number
MRS-8(E).book 103 ページ 2004年7月30日 金曜日 午後5時24分