User's Manual

Reference [Projects]
ZOOM MRS-8
106
This operation duplicates a project that is saved on the SD
card.
1.
Refer to steps 1 – 3 of “Basic procedure” to
bring up the indication “PROJECT COPY”
on the display. Then press the [ENTER] key.
The name and number of the project to copy are shown
on the display.
2.
Turn the dial to select the copy source
project, and press the [ENTER] key.
The display changes as follows.
From this screen, you can select the copy destination
project number.
3.
Turn the dial to select the copy destination
project number, and press the [ENTER] key.
The indication “SURE?” appears on the display.
4.
Press the [ENTER] key to copy the project.
When copying is completed, the copy destination project
is loaded, and the unit returns to the main screen.
By pressing the [EXIT] key instead of the [ENTER] key,
you can cancel the operation and back up one step at a
time.
This operation erases a saved project from the SD card.
NOTE
Once a project has been erased, it cannot be restored. Use
this operation with care.
1.
Refer to steps 1 – 3 of “Basic procedure” to
bring up the indication “PROJECT ERASE”
on the display. Then press the [ENTER] key.
The display changes as follows.
2.
Turn the dial to select the project, and press
the [ENTER] key.
The indication “SURE?” appears on the display.
3.
Press the [ENTER] key to erase the project.
You can also erase the project that is currently loaded. If
you do this, the lowest-numbered project on the SD card
will automatically be loaded after the erase operation has
been completed.
NOTE
A project for which protect is ON cannot be erased. Set
protect to OFF and then repeat the procedure (
→
p. 107).
Copying a project
PRJ COPY
PRJ COPY
PRJ000
PRJ000
0
Project name Project numbe
r
PRJ COPY
PRJ COPY
COPY TO
COPY TO
1
Copy destination project number
Erasing a project
PRJ ERS
PRJ ERS
PRJ002
PRJ002
2
Project name Project numbe
r
MRS-8(E).book 106 ページ ２００４年７月３０日 金曜日 午後５時２４分