User's Manual

Reference [Other Functions]
ZOOM MRS-8
116
Switching the level meter
display type
In the default condition of a project, the level meter below
the display indicates the level of the signal after passing
through the faders (post-fader). If required, you can
change the setting so that the signal before passing
through the level faders (pre-fader) is shown. To do this,
proceed as follows.
1.
From the main screen, press the [SYSTEM/
UTILITY] key in the display section.
The indication “SYSTEM PROJECT” appears on the
display.
2.
Use the cursor left/right keys to bring up
the indication “SYSTEM LVL MET” on the
display, and press the [ENTER] key.
The current level meter setting will be displayed.
The settings have the following meaning.
• POST
The meter shows the level of the signal after passing
through the faders.
• PRE
The meter shows the level of the signal before passing
through the faders.
3.
Turn the dial to change the setting.
4.
When the setting is complete, press the
[EXIT] key repeatedly to return to the main
screen.
Adjusting the display
contrast and backlight
You can adjust the display contrast and turn the backlight
on and off. To do this, proceed as follows.
1.
From the main screen, press the [SYSTEM/
UTILITY] key in the display section.
The indication “SYSTEM PROJECT” appears on the
display.
2.
Use the cursor left/right keys to bring up
the indication “SYSTEM LCD” on the
display, and press the [ENTER] key.
A display related item can be selected.
3.
Use the cursor left/right keys to select
“LIGHT” (backlight on/off) or CONTRAST
(adjust display contrast), and press the
[ENTER] key.
• When LIGHT was selected
Turn the dial to set the backlight to ON or OFF.
• When CONTRAST was selected
Turn the dial to set the contrast in the range from 1 to 8.
4.
When the setting is complete, press the
[EXIT] key repeatedly to return to the main
screen.
LVL MET
LVL MET
POST
POST
LCD
LCD
LIGHT
LIGHT
LIGHT
LIGHT
ON
ON
CONTRAST
CONTRAST
1
MRS-8(E).book 116 ページ ２００４年７月３０日 金曜日 午後５時２４分