User's Manual

ZOOM MRS-8
13
Inserting SD Card and Batteries
Inserting an SD card
For operating the MRS-8, an SD card or a miniSD card
with adapter (capacity 16 MB or more) must be inserted
as storage media. Before inserting a card, verify that the
write protect feature is turned off. Make sure that power
to the MRS-8 is turned off, and then insert the card as
shown below.
When inserting the card, push it all the way into the slot.
To remove the card, turn power off and then pull the card
out.
To remove or insert a card with the power turned on, be
sure to follow the procedure described on page 117.
Otherwise data may be permanently destroyed.
NOTE
• If the card is inserted with wrong orientation, it will not go all
the way in. Never try to force the card, as this may damage it.
Inserting the batteries
The MRS-8 can be powered from batteries. Purchase the
correct batteries and insert them as described below.
1.
Turn the unit over and open the battery
compartment cover.
2.
Insert four IEC R6 (size AA) batteries into
the compartment. (Use alkaline batteries.)
3.
Close the battery compartment cover.
NOTE
If you are operating the unit on battery power and the
indication [ ] appears in the bottom right of the
display, the batteries are almost exhausted. Replace all four
batteries with fresh ones as soon as possible.
SD card
MRS-8 bottom view
Battery compartment
IEC R6 (size AA) battery x 4
MRS-8(E).book 13 ページ ２００４年７月３０日 金曜日 午後５時２４分